Back to Top

StoreYourBoard Vertical Surf Storage Wall Rack – 6 Surfboard Mount

Made by StoreYourBoard, the leaders in outdoor sports gear storage, this Surf Rack is a classic vertical surfboard storage solution!

Holds 6 Surfboards Vertically
The Rack consists of 2 wood wall base pieces and 6 padded arms that insert into the base pieces. Each arm supports 1 surfboard, vertically, and the arms are angled slightly inward to keep your surfboards in the rack and prevent them from leaning and falling out. This also means the rack takes up less space out from your wall than if the arms were straight.

What Surfboards Will it Hold?
This surf rack is designed to hold most all surfboards on the market, from shortboards to longboards, and everything in between, like fish, funshapes, Wavestorms, Catch Surf boards, boogey boards, skimboards and more. NOT intended for SUPs.

Light Assembly and Mounting
Assembly of this rack is quick and easy. You’ll insert and glue the rack arms into the base pieces. Then 2 screws through each base piece secure the rack against the wall, and you’re ready to store your boards. All the hardware + glue you need to assemble and install the rack is included.

Practical, Functional Surfboard Storage
This rack may not win any awards for aesthetics: the wood base pieces are unfinished and the 3/4″ thick foam padding on the rack arms is not fancy. But if you want something to get the job done for your surfboards, this rack is it! As an added bonus, this is hand made in the USA!

Dimensions
-2 wood rack base pieces, each are 32″ wide (64″ total)
-6 included arms are 16″ long; stick out 14″ from wall
-Horizontal distance between arms of 14″ fits most fins
-Arms angled approximately 25 degrees inward
-3/4″ foam padding on arms

Product Features

  • 6 SURFBOARD STORAGE: store your 6 surfboards at home or in your surf shop, from shortboards to longboards.
  • CLASSIC DESIGN: vertical storage is a compact board storage solution and a must for a large quiver.
  • FUNCTIONAL, NOT FANCY: nothing fancy about this rack, but it will hold your boards where you need them.
  • PROTECTS YOUR BOARDS: foam padded arms protect your boards and the angled arms help hold them securely in place.
  • HANDMADE IN USA! Support American-made products and businesses.

Reblogged 6 years ago from www.amazon.com

Comments

Anonymous says:

THe holes in the base dont match up in size with the support arms. The support arms were either too big or too small. When they were too big it caused the base wood to start to split when hammering in the arms. When they were too small it just falls right out, obviously not going to stay in there with a surfboard leaning against it. Also the super glue they give runs out by the third whole. The measurements are off and just a very poor design for something that is suppose to support something…

Leave a Reply